Remko RM Series Manual do Utilizador Página 14

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 36
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 13
Maintenance
■
It is recommended that you
take out a maintenance
contract with an annual service
from an appropriate specialist
firm.
Cleaning the condensation
pump (accessory)
The indoor unit may include a built-
in or separate condensation pump
for pumping the condensation to a
drain at a higher level.
Observe the care and maintenance
instructions specified in the
separate manual.
Type of task
Checks/Maintenance/Inspection
Commissioning
Monthly
Six-monthly
Yearly
General
Measure voltage and current
Check compressor/fans are functioning correctly
Check fans are functioning correctly
Dirt on liquefier/vaporiser
Check refrigerant fill quantity
Check condensation drain
Test insulation
Check moving parts
Cleaning the housing of the
indoor unit
1. Disconnect the supply voltage
to the equipment.
2. Open and lift the front air inlet
guard.
3. Clean the guard using a soft,
damp cloth.
4. Switch the supply voltage back
on.
Air filter for indoor unit
Clean the air filter at least every 2
weeks. Reduce this interval if the
air is especially dirty.
Cleaning the filter in the
indoor unit
1. Disconnect the supply voltage
to the equipment.
2. Open the front of the unit by
lifting the guard and latching it
in position (Fig. 2).
3. Lift the filter and pull it down
and out.
3 Clean with a vacuum cleaner
4
Cleaning with lukewarm water
This ensures the operational
reliability of your equipment!
TIP
4. Clean the filter using a normal
vacuum cleaner. The dirty side
should be face up (Fig. 3).
5. Any dirt can be cleaned off
using lukewarm water and mild
cleaning agents. The dirty side
should be face down (Fig. 4).
6. If water is used, let the filter
dry out properly in air before
replacing it in the unit.
7. Carefully insert the filter. Ensure
it locates correctly.
8. Close the front of the unit
in the reverse order to that
described above.
9. Switch the supply voltage back
on.
10.
Switch the unit back on.
2 Lift the guard
REMKO RM
14
Vista de página 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comentários a estes Manuais

Sem comentários